BoilerFaultCodesYour boiler has switched itself off because it got too hot, likely triggered by a safety sensor to prevent damage.
Book a Gas Safe engineer within 24–48 hours. Your boiler may be unsafe or could break down completely if left.
Technical description: If the overheat Safety Temperature Limiter operates as indicated by illuminated reset light, open the controls cover and turn temperature control to “0” (anticlockwise) and then back to original position.
What causes this fault?
This fault occurs when the water inside the boiler reaches an unsafe temperature, forcing the system to shut down for safety. It is usually caused by a failure to move heat away from the boiler quickly enough, often due to a broken pump or a blockage in the internal pipework. In some cases, a faulty sensor may mistakenly signal that the unit is overheating even when temperatures are normal.
This issue is more frequent during the first cold snap of autumn when pumps that have been idle all summer often seize up upon being switched back on.
DIY fix possible
Open the small control cover on the front of the boiler.Turn the temperature control knob fully anticlockwise to the '0' position.Wait a few seconds, then turn the knob back to your original desired temperature setting to restart the boiler.
Find a Gas Safe engineer
Search the official register for a qualified engineer in your area.
Gas Safe Register →Protect yourself from future repair bills
A boiler cover plan would cover faults like Reset light — no call-out fees, no surprises.
Affiliate links — we may earn a commission at no extra cost to you.
Glow-worm Micron 30ff is discontinued — time for a new one?
Parts for discontinued models can be hard to find and expensive. A new A-rated boiler could save you money on both repairs and energy bills.
Affiliate links — we may earn a commission at no extra cost to you.