BoilerFaultCodesYour boiler is currently trying to light the flame and this light will turn off as soon as the burner is successfully lit.
This is a minor fault. Keep an eye on it and mention it at your next annual boiler service. Reset the boiler and see if it clears.
Technical description: Flashes to indicate ignition operation (stops after detection)
What causes this fault?
This light activates during the ignition sequence as the boiler attempts to create a flame. It indicates that the internal controls are sending power to the spark generator and opening the gas valve to start the heating process. If this light stays on for a long time without the boiler firing up, it usually means the fuel is not reaching the burner or the spark is too weak to ignite it.
DIY fix possible
Observe the light for a few seconds to see if it stops flashing once the boiler starts runningCheck that your gas supply is turned on at the meterEnsure your thermostat is calling for heat
Find a Gas Safe engineer
Search the official register for a qualified engineer in your area.
Gas Safe Register →Protect yourself from future repair bills
A boiler cover plan would cover faults like Neon SG1 — no call-out fees, no surprises.
Affiliate links — we may earn a commission at no extra cost to you.
Ideal Classic SE FF is discontinued — time for a new one?
Parts for discontinued models can be hard to find and expensive. A new A-rated boiler could save you money on both repairs and energy bills.
Affiliate links — we may earn a commission at no extra cost to you.