BoilerFaultCodesYour boiler is having trouble communicating with your wall thermostat, meaning it doesn't know when to turn your heating on or off.
This fault should be looked at by a Gas Safe engineer within the next week or two. It may get worse if left.
Technical description: Room Thermostat Fault: Check Room Stat & connections
What causes this fault?
This fault occurs when the boiler loses its physical or wireless connection to the wall thermostat, leaving it unable to receive an instruction to start. The most common reasons are dead batteries in the room thermostat or a loose wire in the terminal block where the controls connect to the boiler. In some cases, it can be caused by signal interference or a hardware failure within the thermostat unit itself.
This fault is often noticed during the first cold spell of autumn when homeowners try to turn their heating back on after a long summer of inactivity.
DIY fix possible
Check if your room thermostat is switched on and hasn't run out of batteries.Ensure the thermostat is set to a temperature higher than the current room temperature.If using a wireless thermostat, check that the receiver next to the boiler is showing power and try re-pairing the device.
Find a Gas Safe engineer
Search the official register for a qualified engineer in your area.
Gas Safe Register →Protect yourself from future repair bills
A boiler cover plan would cover faults like F 0t — no call-out fees, no surprises.
Affiliate links — we may earn a commission at no extra cost to you.