BoilerFaultCodesYour boiler has stopped working because the water pressure is too low or water isn't moving through the system correctly.
Book a Gas Safe engineer within 24–48 hours. Your boiler may be unsafe or could break down completely if left.
Technical description: 1 With boiler off & system cold, fill system to 1.0bar. 2 Bleed radiators, refill system to 1.0bar. 3 If fault persists, contact installer.
What causes this fault?
This fault occurs when the boiler's internal sensors detect that water is not moving through the unit, which is a safety mechanism to prevent the components from overheating. The most common reason is a simple drop in system pressure caused by a small leak or air trapped in the radiators, though it can also be triggered by a blockage or a failing pump. Essentially, the boiler has detected it is 'running dry' and has shut down to protect itself from damage.
This issue often appears in autumn when the heating is turned on for the first time after summer, as air bubbles can settle or small leaks can develop while the system is dormant.
DIY fix possible
Check the pressure gauge and use the filling loop to top up the system to 1.0 barBleed all radiators to remove trapped airEnsure all radiator valves and boiler isolation valves are fully open
Find a Gas Safe engineer
Search the official register for a qualified engineer in your area.
Gas Safe Register →Protect yourself from future repair bills
A boiler cover plan would cover faults like No Water Flow — no call-out fees, no surprises.
Affiliate links — we may earn a commission at no extra cost to you.
Could it be time for a new boiler?
If repair costs are adding up, a new energy-efficient boiler could be the smarter long-term choice.
Affiliate links — we may earn a commission at no extra cost to you.