BoilerFaultCodesYour boiler is currently running a self-check program to fill the heating system with water and is not experiencing a permanent fault.
This is a minor fault. Keep an eye on it and mention it at your next annual boiler service. Reset the boiler and see if it clears.
Technical description: Filling mode test program
What causes this fault?
This occurs when the boiler is manually or automatically triggered to run its internal filling program to reach the correct operating pressure. It usually happens after the system has been drained for repairs or when the water pressure has dropped too low and needs topping up. While this code is active, the boiler is simply prioritizing getting the water levels right before it starts heating your home again.
DIY fix possible
Wait approximately 15 minutes for the program to finish automaticallyEnsure your filling loop valves are closed once the pressure reaches 1.5 barIf the code persists, press and hold the 'Reset' button (flame icon) for 3 seconds
Find a Gas Safe engineer
Search the official register for a qualified engineer in your area.
Gas Safe Register →Protect yourself from future repair bills
A boiler cover plan would cover faults like P.06 — no call-out fees, no surprises.
Affiliate links — we may earn a commission at no extra cost to you.