Low
STOP on Atag E Range

Your boiler is telling you that the internal water pressure has successfully returned to the correct level after you topped it up.

Reviewed by the BoilerFaultCodes Editorial Team · Last reviewed

Monitor it

This is a minor fault. Keep an eye on it and mention it at your next annual boiler service. Reset the boiler and see if it clears.

Technical description

Water pressure reach the required level during filling (1.5 to 1.7 bar)

DIY fix possible

Check your boiler display to see if the message has cleared automaticallyIf the boiler is still showing 'STOP', try pressing the reset button onceMonitor the pressure gauge on the front of the boiler to ensure it remains between 1.0 and 2.0 bar

Find a Gas Safe engineer
Search the official register →

Related guides you might find useful

Boiler keeps losing pressure

Six most common causes of dropping pressure.

Read →

Yellow or orange flame — CO safety

Safety-critical — turn off, read this.

Read →

Is boiler cover worth it?

Break-even maths on monthly cover.

Read →