Low
StBY on Atag Q 30CR

Your boiler is currently in standby mode and is working exactly as it should, waiting for a signal from your thermostat or hot water tap to start operating.

Reviewed by the BoilerFaultCodes Editorial Team · Last reviewed

Monitor it

This is a minor fault. Keep an eye on it and mention it at your next annual boiler service. Reset the boiler and see if it clears.

What the manual says

Manufacturer manual

Standby mode.

From this model's manual
Verified against the Atag Q 30cr installation & service manual.
Plain-English guidance below. Severity, DIY steps, costs and parts are our interpretation to help you act, not text from the manual.

DIY fix possible

Check your room thermostat is set to a higher temperature than the current room temperatureEnsure your heating timer or programmer is set to 'On'Turn on a hot water tap to see if the boiler fires up

Find a Gas Safe engineer
Search the official register →
Boiler cover options

Avoid the next call-out bill

A cover plan would handle faults like StBY: no call-out fees, no surprise bills.

Approved partner
Domestic Appliance Guard
Unlimited call-outs, 24/7 helpline, no price-hike promise
Get a quote →

Affiliate links. We may earn a commission at no extra cost to you.

Related guides you might find useful

No hot water but heating works

Almost always a stuck diverter valve on combis.

Read →

Boiler won't turn on — 9-step checklist

Work through these before the call-out.

Read →

Is boiler cover worth it?

Break-even maths on monthly cover.

Read →