High
LED 6 (D.H.W.) on Ferroli Arean

Your boiler has stopped working because it has detected a technical fault related to the water pressure or internal temperature sensors.

Reviewed by the BoilerFaultCodes Editorial Team · Last reviewed

Call an engineer soon

Book a Gas Safe engineer within 24 to 48 hours. Your boiler may be unsafe or could break down completely if left.

Technical description

Short circuit on D.H.W. sensor (42) or resistance lower than 500 Ohm; C.H. limit thermostat (50) open circuit (pump run); C.H. water pressure low(114 open circuit).

Engineer required

This is a high severity fault. Stop using the boiler and call a Gas Safe registered engineer. Do not attempt gas-related repairs yourself.

Find a Gas Safe engineer
Search the official register →

Related fault codes

LED 1View →LED 2View →

Related guides you might find useful

No hot water but heating works

Almost always a stuck diverter valve on combis.

Read →

Boiler keeps losing pressure

Six most common causes of dropping pressure.

Read →

Boiler won't turn on — 9-step checklist

Work through these before the call-out.

Read →