Low Information
P7 on Ideal Logic Max Combi

Your boiler is displaying a configuration message regarding how fast its internal pump should run to move water through your radiators.

Reviewed by the BoilerFaultCodes Editorial Team · Last reviewed

Monitor it

This is a minor fault. Keep an eye on it and mention it at your next annual boiler service. Reset the boiler and see if it clears.

Technical description

To set the minimum CH pump speed to 70% (default)

What causes this fault?

This message is not actually a fault, but an internal setting used to manage how the pump circulates water during the installation or maintenance process. It appears when the boiler needs to confirm the minimum speed of the internal pump to ensure water flows efficiently through your radiators. Normally, this occurs after a power cut or when a technician is adjustng the system's efficiency settings.

DIY fix possible

Press the 'RESTART' button to confirm the setting and clear the code from the display.If the code persists, check that the boiler pressure is between 1 and 1.5 bar.If the code returns frequently, contact a Gas Safe engineer to check the pump settings in the installer menu.

Find a Gas Safe engineer
Search the official register →

Related fault codes

P1View →

Related guides you might find useful

Banging / kettling / whistling noise

Each noise points to a different fault.

Read →

Radiators cold at the bottom

Sludge build-up — needs flushing, not bleeding.

Read →

Yellow or orange flame — CO safety

Safety-critical — turn off, read this.

Read →