Low Information
uP on Ideal Logic Max Combi

Your boiler has detected that it was turned on while its internal computer chip was being replaced or updated.

Reviewed by the BoilerFaultCodes Editorial Team · Last reviewed

Monitor it

This is a minor fault. Keep an eye on it and mention it at your next annual boiler service. Reset the boiler and see if it clears.

Technical description

Boiler powered on during PCB replacement

What causes this fault?

This fault occurs when the boiler's main control board is powered on while the firmware chip is being handled or the system is in an incomplete update state. It typically happens if the electricity is turned back on before a technician has fully finished swapping out the internal computer components. It essentially means the boiler’s brain wasn't ready to start up when the power hit it.

DIY fix possible

Locate the main power switch for the boiler (usually a fused spur switch nearby).Turn the power off completely.Wait for 30 seconds.Turn the power back on and the code should disappear.

Find a Gas Safe engineer
Search the official register →

Related fault codes

F2View →

Related guides you might find useful

Yellow or orange flame — CO safety

Safety-critical — turn off, read this.

Read →

When to replace your boiler

7 signs repair isn't worth it anymore.

Read →

Is boiler cover worth it?

Break-even maths on monthly cover.

Read →