Low Information
S.07 on Vaillant ecoTEC Plus 832

Your boiler is briefly running the pump after heating your radiators to safely move residual heat away from the unit.

Reviewed by the BoilerFaultCodes Editorial Team · Last reviewed

Monitor it

This is a minor fault. Keep an eye on it and mention it at your next annual boiler service. Reset the boiler and see if it clears.

Technical description

Heatingmode:Pumpoverrun

What causes this fault?

This status occurs when the heating cycle finishes and the boiler keeps the pump spinning for a few minutes. It physically pushes the remaining hot water out of the heat exchanger and into your pipes to prevent the internal components from overheating. It is a normal safety function rather than a mechanical failure.

DIY fix possible

Check that at least one radiator (usually one without a thermostatic valve) is fully open to allow water to circulateWait for the code to clear automatically after a few minutesEnsure your system pressure is between 1.0 and 1.5 bar on the display

Find a Gas Safe engineer
Search the official register →

Related fault codes

S.06View →S.08View →F.20View →

Related guides you might find useful

Banging / kettling / whistling noise

Each noise points to a different fault.

Read →

Radiators cold at the bottom

Sludge build-up — needs flushing, not bleeding.

Read →

Is boiler cover worth it?

Break-even maths on monthly cover.

Read →