BoilerFaultCodesWhat the manual says
Manufacturer manualHeating mode: No requirement
What causes this fault?
This code appears when the boiler has reached its desired temperature or the room thermostat has signaled that the house is warm enough. It is not a fault, but rather the boiler sitting in an idle state to save energy until the temperature drops again. Once the thermostat detects a need for heat, the boiler will automatically restart its firing sequence.
This status is much more frequent during the summer or shoulder months when the heating is turned off or the outdoor temperature is high enough that the thermostat rarely triggers.
DIY fix possible
Check if your room thermostat is turned up higher than the current room temperatureEnsure your heating programmer or timer is set to 'ON'Check that the batteries in your wireless thermostat have not run out
Avoid the next call-out bill
Monthly cover means no unexpected bills when your boiler breaks down.
Affiliate links. We may earn a commission at no extra cost to you.