What the manual says
Manufacturer manualNormal operation, remote control not functioning. Cause: Lead break, PlusBus cable, incorrect appliance address set, remote control faulty
DIY fix possible
Check the batteries in the remote control and replace them if they are low or flat.Make sure the remote control is switched on and the display is working.Switch the boiler off at its on/off switch, wait 30 seconds, then switch it back on to reset the connection.Check that the wires connecting the remote control to the boiler are not visibly damaged or loose at either end, but do not open the boiler casing.If the code returns, contact a Gas Safe registered engineer to check the PlusBus cable, the boiler's appliance address setting and the remote control itself.
Avoid the next call-out bill
Monthly cover means no unexpected bills when your boiler breaks down.
Affiliate links. We may earn a commission at no extra cost to you.
All 151 fault codes on the Vitodens 100-W B1HF-11
Seeing a different code? Every code this model can display, in one place.