Common problems guide

The most common Worcester Bosch Greenstar 27i System Compact ErP problems

The faults most likely to send a Worcester Bosch Greenstar 27i System Compact ErP into lockout — with plain-English causes, what to check first, estimated repair costs and whether you need a Gas Safe engineer.

65 documented codes
6 most common
3 DIY-safe checks
3 engineer needed

The 6 most common faults

01
207 High DIY-safe

Your boiler has temporarily stopped working because the water pressure inside the heating system has dropped too low.

What to try first

Locate the filling loop connected to your boiler or under the sink.Open the valves slowly to let water into the system until the pressure gauge reads between 1.0 and 1.5 bar.Close the valves firmly and check the display to see if the error clears.

Parts
Filling loop, Pressure relief valve, Pressure sensor
Full guide for 207
02
EA High DIY-safe

Your boiler has tried to light several times but has been unable to detect a flame, causing the system to shut down for safety.

What to try first

Check if your gas supply is active by testing other gas appliances like a hobEnsure your gas meter has credit if you use a pre-payment meterPress and hold the 'Reset' button for five seconds to see if the boiler restartsCheck that the condensate pipe (outside white plastic pipe) isn't frozen if the weather is very cold

Est. cost
£100-350
Parts
Ignition Electrode, Flame Sensor (Ionisation Probe), Gas Valve
Full guide for EA
03
F0 High DIY-safe

Your boiler's internal computer has encountered a software or electronic error and can no longer control the heating properly.

What to try first

Press the 'Reset' button on the front of the boiler once.If it does not reset, turn the power supply to the boiler off at the fused spur switch.Wait 60 seconds and then turn the power back on.

Est. cost
£250-450
Parts
Main Printed Circuit Board (PCB), Wiring Harness
Full guide for F0
04
205 High Engineer

Your boiler is struggling to clear exhaust gases before ignition, so it has paused itself to ensure it is safe to operate.

Est. cost
£150-300
Parts
Fan, Air pressure switch, Flue seals
Full guide for 205
05
208 High Engineer

Your boiler is currently locked in a testing mode used by engineers to check the flue system, which prevents it from heating your home normally.

Est. cost
£100-200
Parts
Flue limit switch, PCB, Wiring harness
Full guide for 208
06
210 High Engineer

Your boiler has temporarily stopped working because it has detected a blockage or a safety issue with the airflow and exhaust gases.

Est. cost
£150-£300
Parts
Air pressure switch, Flue-gas thermostat, Fan assembly
Full guide for 210

on the Worcester Bosch Greenstar 27i System Compact ErP

Filling loopPressure relief valvePressure sensorIgnition ElectrodeFlame Sensor (Ionisation Probe)Gas Valve

Based on parts cited in our fault code database. Your engineer will confirm what's actually needed after diagnosis.

Call a Gas Safe engineer if…

  • You can smell gas or see signs of a leak
  • The Worcester Bosch shows an Emergency or High severity code
  • The boiler keeps locking out after repeated resets
  • You've tried the DIY checks and the fault hasn't cleared
  • There's visible water leaking from the boiler
  • The flame is yellow or orange instead of blue

Avoid the next call-out bill

Monthly cover means no unexpected bills when your boiler breaks down.

Approved partner
Domestic Appliance Guard
Unlimited call-outs, 24/7 helpline, no price-hike promise
Get a quote →

Affiliate links. We may earn a commission at no extra cost to you.

See the full 65-code list for the Worcester Bosch Greenstar 27i System Compact ErP