High
Block 80 on Atag E32S

Your boiler has switched itself off because the waste gases exiting the flue are dangerously hot, indicating your system is struggling to vent heat properly.

Reviewed by the BoilerFaultCodes Editorial Team · Last reviewed

Call an engineer soon

Book a Gas Safe engineer within 24 to 48 hours. Your boiler may be unsafe or could break down completely if left.

What the manual says

Manufacturer manual

Maximum flue gas temperature has been exceeded (if present). The block will not be cancelled until the flue gas temperature has lowered to a correct figure.

From this model's manual
Verified against the Atag E32s installation & service manual.
Plain-English guidance below. Severity, DIY steps, costs and parts are our interpretation to help you act, not text from the manual.

Engineer required

This is a high severity fault. Stop using the boiler and call a Gas Safe registered engineer. Do not attempt gas-related repairs yourself.

Find a Gas Safe engineer
Search the official register →
Boiler cover options

Avoid the next call-out bill

A cover plan would handle faults like Block 80: no call-out fees, no surprise bills.

Approved partner
Domestic Appliance Guard
Unlimited call-outs, 24/7 helpline, no price-hike promise
Get a quote →

Affiliate links. We may earn a commission at no extra cost to you.

Related fault codes

Block 81View →Block 82View →

Related guides you might find useful

Banging / kettling / whistling noise

Each noise points to a different fault.

Read →

Radiators cold at the bottom

Sludge build-up — needs flushing, not bleeding.

Read →

When to replace your boiler

7 signs repair isn't worth it anymore.

Read →