High Lockout
06 on Viessmann Vitodens 100-W / 200-W

Your boiler has detected a sequence of ignition or flame detection errors and has shut itself down for safety.

Reviewed by the BoilerFaultCodes Editorial Team · Last reviewed

Call an engineer soon

Book a Gas Safe engineer within 24 to 48 hours. Your boiler may be unsafe or could break down completely if left.

Technical description

Burner control switches to lockout

What causes this fault?

This fault occurs when the boiler's internal computer fails to detect a reliable flame during the ignition process. The most common reasons are worn-out sparks that can no longer light the gas, or a dirty sensor that cannot 'see' the flame even after it has started. It can also be caused by a lack of gas reaching the burner due to a faulty valve or a blockage in the air supply.

Engineer required

This is a high severity fault. Stop using the boiler and call a Gas Safe registered engineer. Do not attempt gas-related repairs yourself.

Find a Gas Safe engineer
Search the official register →

Related fault codes

F4View →F2View →

Related guides you might find useful

Boiler keeps cutting out

Lockout fault with a reset-needed pattern.

Read →

Pilot light keeps going out

Older boilers — thermocouple, draught, gas supply.

Read →

Yellow or orange flame — CO safety

Safety-critical — turn off, read this.

Read →