Low
Boiler stand-by on Vokera Easi-Heat Plus

Your boiler is currently in standby mode and is working exactly as it should, waiting for a signal from your thermostat or hot water tap to start heating.

Reviewed by the BoilerFaultCodes Editorial Team · Last reviewed

Monitor it

This is a minor fault. Keep an eye on it and mention it at your next annual boiler service. Reset the boiler and see if it clears.

What the manual says

Manufacturer manual

Boiler stand-by

Shared across the Easi-Heat Plus range
This code is shared by the boilers in this range, which use the same control board. It may not be printed in this exact variant’s manual.
Plain-English guidance below. Severity, DIY steps, costs and parts are our interpretation to help you act, not text from the manual.

DIY fix possible

Check your room thermostat or smart controller is set to a temperature higher than the current room temperature.Ensure your programmer or timer is set to the 'On' or 'Timed' position.Try opening a hot water tap to see if the boiler fires up to heat water.

Find a Gas Safe engineer
Search the official register →
Boiler cover options

Avoid the next call-out bill

Monthly cover means no unexpected bills when your boiler breaks down.

Approved partner
Domestic Appliance Guard
Unlimited call-outs, 24/7 helpline, no price-hike promise
Get a quote →

Affiliate links. We may earn a commission at no extra cost to you.

All 8 fault codes on the Easi-Heat Plus

Seeing a different code? Every code this model can display, in one place.

Alarm high limit thermostatAlarm system water pressureFault sensorsFlame ONPurge cycle mode activeService operationTemporary fault

Related guides you might find useful

No hot water but heating works

Almost always a stuck diverter valve on a combi.

Read →

Is boiler cover worth it?

Break-even maths on monthly cover.

Read →

When to replace your boiler

7 signs repair isn't worth it anymore.

Read →