High
2950 B on Worcester Bosch 26 CDi Xtra

Your boiler is failing to detect a flame after trying to start, which means it will not provide heating or hot water until it is reset or repaired.

Reviewed by the BoilerFaultCodes Editorial Team · Last reviewed

Call an engineer soon

Book a Gas Safe engineer within 24 to 48 hours. Your boiler may be unsafe or could break down completely if left.

Technical description

No flame signal. Following starting procedure the burner starts automatically. After cleaning set the correct gas / air ratio correctly

Engineer required

This is a high severity fault. Stop using the boiler and call a Gas Safe registered engineer. Do not attempt gas-related repairs yourself.

Find a Gas Safe engineer
Search the official register →

Related fault codes

EAView →

Related guides you might find useful

Boiler keeps cutting out

Lockout fault with a reset-needed pattern.

Read →

No hot water but heating works

Almost always a stuck diverter valve on combis.

Read →

Pilot light keeps going out

Older boilers — thermocouple, draught, gas supply.

Read →