Low
S.0 on Glow-worm Ultimate3 System

Your boiler is currently in standby mode because it has not been asked to provide any heating or hot water.

Reviewed by the BoilerFaultCodes Editorial Team · Last reviewed

Monitor it

This is a minor fault. Keep an eye on it and mention it at your next annual boiler service. Reset the boiler and see if it clears.

What the manual says

Manufacturer manual

Heating mode: No requirement

From this model's manual
Verified against the Glow Worm Ultimate3 System installation & service manual, page 42.
Plain-English guidance below. Severity, DIY steps, costs and parts are our interpretation to help you act, not text from the manual.

DIY fix possible

Check your room thermostat or smart controller settingsEnsure your heating timer is set to the 'On' positionIncrease the target temperature on your thermostat to see if the boiler initiates a heating cycle

Find a Gas Safe engineer
Search the official register →
Boiler cover options

Avoid the next call-out bill

Monthly cover means no unexpected bills when your boiler breaks down.

Approved partner
Domestic Appliance Guard
Unlimited call-outs, 24/7 helpline, no price-hike promise
Get a quote →

Affiliate links. We may earn a commission at no extra cost to you.

Related fault codes

S.1View →S.2View →S.4View →

Related guides you might find useful

No hot water but heating works

Almost always a stuck diverter valve on combis.

Read →

Is boiler cover worth it?

Break-even maths on monthly cover.

Read →

When to replace your boiler

7 signs repair isn't worth it anymore.

Read →