BoilerFaultCodesWhat the manual says
Manufacturer manualTo set the minimum CH pump speed to 70% (default)
What causes this fault?
This code appears when the boiler is being programmed to its standard factory setting for how fast the internal pump should circulate water. It is not an error or a component failure, but rather a confirmation that the pump will run at a minimum of 70% speed during heating cycles. You will usually only see this during commission or if someone has been adjusting the installer settings.
DIY fix possible
Press the 'Mode' or 'Reset' button to return the screen to the standard temperature displayObserve if the code disappears and the boiler operates normallyNo further action is required if heating and hot water are functioning
Avoid the next call-out bill
A cover plan would handle faults like P7: no call-out fees, no surprise bills.
Affiliate links. We may earn a commission at no extra cost to you.