Low Information
D.014 on Vaillant ecoTEC Pro 28

This is a technical setting that controls how fast your boiler's internal pump circulates water throughout your heating system.

Reviewed by the BoilerFaultCodes Editorial Team · Last reviewed

Monitor it

This is a minor fault. Keep an eye on it and mention it at your next annual boiler service. Reset the boiler and see if it clears.

Technical description

Diagnostics code: Setting the pump output

What causes this fault?

This isn't a mechanical failure, but rather a configuration setting that has been accessed or adjusted within the boiler's menu. It happens when an engineer or user enters the diagnostic mode to change the speed at which the pump moves hot water around your radiators. It is used to balance the system's efficiency and noise levels rather than to report a broken part.

Engineer required

This fault requires a Gas Safe registered engineer. Do not attempt gas-related repairs yourself.

Find a Gas Safe engineer
Search the official register →

Related fault codes

F.75View →

Related guides you might find useful

Banging / kettling / whistling noise

Each noise points to a different fault.

Read →

Yellow or orange flame — CO safety

Safety-critical — turn off, read this.

Read →

Is boiler cover worth it?

Break-even maths on monthly cover.

Read →