Low Information
S.05 on Glow-worm Flexicom cx

Your boiler is simply cooling itself down after finishing a heating or hot water cycle and will restart normally once it has finished.

Reviewed by the BoilerFaultCodes Editorial Team · Last reviewed

Monitor it

This is a minor fault. Keep an eye on it and mention it at your next annual boiler service. Reset the boiler and see if it clears.

Technical description

pump / fan overrun

What causes this fault?

This occurs when the boiler has reached its required temperature and needs to shift excess heat away from the internal heat exchanger. The pump and fan continue to run for a short period to prevent the unit from overheating and to protect the internal components. It is a natural part of the boiler's operating cycle and indicates the system is managing its temperature correctly.

DIY fix possible

Wait for the boiler to complete its cooling cycle, which usually takes several minutes.Ensure your internal radiator valves (TRVs) are open to allow water to circulate.Check that the system pressure is between 1.0 and 1.5 bar on the display.

Find a Gas Safe engineer
Search the official register →

Related fault codes

S.01View →S.02View →S.03View →

Related guides you might find useful

No hot water but heating works

Almost always a stuck diverter valve on combis.

Read →

Yellow or orange flame — CO safety

Safety-critical — turn off, read this.

Read →

Is boiler cover worth it?

Break-even maths on monthly cover.

Read →